You will see the values change and hear the TB cycle for the first few seconds then it will stop. The TB adaptation is being done as soon as you switched basic settings on. Once you do this you will see the top right display say ADP RUN. It should now say "Basic Settings: ON" on the top of your screen. It should say "Basic Settings: OFF" on the top of your screen. Some examples of CAN engine controllers are the Mk5 Golf 2.0T FSI) An example of a KWP-2000 engine controller is the 2002+ B6 Audi A4 1.8T. Check to see if the engine speaks KWP-2000 or CAN by looking in the top left of the Open Controller Screen. (These are engines WITHOUT a physical cable between the accelerator and the throttle.
![vcds jetta vcds jetta](https://static.wikia.nocookie.net/despicableme/images/e/ef/The_minions_in_Minions.jpeg)
![vcds jetta vcds jetta](https://i0.wp.com/intheplayroom.co.uk/wp-content/uploads/2015/06/minionsposter.jpg)
The Accelerator Pedal has been removed and reinstalled.The Throttle Body has been cleaned or removed and reinstalled.The ECU has been removed and reinstalled.
![vcds jetta vcds jetta](https://obrazki.elektroda.pl/2145178100_1354817355.png)
The vehicle's battery has been disconnected and re-connected.Some examples of reasons to perform a TBA: This procedure cycles the motorized throttle body through various states (idle, part throttle, WOT) to relearn their positions.
#Vcds jetta how to
This procedure details how to perform a Throttle Body Alignment (TBA) on many VW/Audi vehicles with Gasoline engines.
#Vcds jetta manual
As always, you should refer to a Factory Repair Manual for your vehicle!
![vcds jetta vcds jetta](https://i.ytimg.com/vi/oVJH9-YyGEQ/hqdefault.jpg)
Ross-Tech is not responsible for any damage or problems that may result from following these instructions.